How to use self inflating mats

Zhejiang Hongfeng Outdoor Products Co., Ltd.(zjhf.com): Instructions for use of self inflating mats

1. First use:

1) Spread the air cushion

2) Open the air nozzle to automatically expand the air bed. Close the air nozzle, fold the air bed repeatedly in half, and then press hard for a few times, then open the valve to let the air bed expand automatically and fully restore its elasticity and shape.

2, inflation method:

1) Unfold the air cushion and open the air nozzle, the air bed will automatically start to expand.

2) Please wait until the air bed is inflated, and then tighten the air nozzle cover.

3) Adjust the air pressure to adjust its comfortable hardness.

 Note: If you keep it in a rolled state for a long time (not recommended), please inflate it with your mouth several times to restore its elasticity.

3, the method of exhaust:

 1) Open the air nozzle, roll up from the other end of the air nozzle, and press out air.

2) Close the air nozzle, roll up the air bed from the other end, and open the air nozzle again to exhaust the remaining air.

3) Finally, close the valve, and it can be rolled up and saved at any time.

Note: Please put it in the outer bag when carrying it to avoid scratches.

4. Storage method:

 Spread the air cushion, open the air nozzle, and store it in a cool and dry place (for example: under the bed or behind the sofa, etc.), because the sponge of the air bed has a memory shape and can quickly expand into the most commonly used shape.

 

5. Repair method:

1) Confirm the leaking place: After blowing the air, close the valve, wet the surface with water or dilute soapy water, fold it in half, press it with your knees and pressurize with your weight. The bubbling place is the leaking place. Make a mark.

2) Repair of small holes: completely dry the air bed, let out the air, and drip adhesive on the holes. Because the air is exhausted, the adhesive will be inhaled, sealing the hole. Then wait for the adhesive to harden.

3) Repair of major damage: completely dry the air bed to deflate the air, apply glue on the patch of repair cloth, and apply glue to the hole on the surface of the air bed, dry for 30 seconds to 3 minutes (depending on the temperature), and fit it on the damaged Place, flatten, and keep for 4 hours before use.

6. Clean:

Expand the air bed to the maximum limit, close the valve tightly, use a soft brush and low-irritating household degreasing detergent or lotion, rinse thoroughly with water after washing in the bathtub, and store it after being completely dried.

7. Matters needing attention:

1) Do not approach sharp objects (thorny plants or sharp stones or blades).

2) When you are not using the tent, please lay a base cloth under the air bed.

3) Do not use it as a float.

4) Keep away from flames or sparks.

5) When the temperature is high, do not place the inflated air bed with the valve closed in the car or tent.

6) Do not stick to sunscreen oil or alkaline medicine.

7) Do not expose to the sun for a long time, as ultraviolet rays will slowly damage the surface material.

8) Please place it out of the reach of pets.

9) The gas nozzle is hard, so you should avoid it when you are resting.